Anycubic Photon M3 Max and M7 Max Vat Double Drip Stand

This is a vat drip stand that can accommodate both the Anycubic M3 Max and M7 Max vat size on either side of the same drip stand so you can drain 2 vats at the same time if you want. Putting a second vat in the holder is tough when one is already up there but it's a problem I have to deal with with the limited space that I have to fit this in. 

Included are the following models (STP and STL files uploaded), all of which print without supports:

Base: Base that fits a 2020 extrusion down the middle, and can use 2x M3x8 socket head fasteners with 2020 hammer nuts to secure it to the extrusion. Please screw this base to something or make it larger. It is not designed to be freestanding while supporting vats. It would probably stand but that's a risk I'm not willing to take. 

Funnel: simple funnel that holds 6" diameter paint strainers, and sits nicely in the funnel holder. I found some on Amazon that are 6" wide x 5" tall and they fit okay. 

Funnel Holder: Holds the funnel above. Will fit any other funnel, just check your clearance to the 2020 extrusion, it might be tight. Use 2x M3x8 fasteners and nuts to secure it in place.

Filter Holder: a little stand to hold extra paint filters because why not? Use 2x M3x8 fasteners and nuts to secure it in place.

Vat Holder: the reason why you're here. I did not edit the M3 max vat holder geometry from the model that I'm remixing. It works fine so I left it as it. I just added another couple lips to accommodate the larger M7 vat. Use 2x M3x8 fasteners and nuts to secure it in place.

Full Assembly: full assembly of all above components assembled on a 2020 extrusion.