1 / 2
Fan duct for Noctua NF-A15 and NF-A14x25r on Minisforum BD790i and it's variants in Fractal Ridge case — zdjęcie 1
1 / 2

Fan duct for Noctua NF-A15 and NF-A14x25r on Minisforum BD790i and it's variants in Fractal Ridge case

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Fan duct for Noctua NF-A15 and NF-A14x25r on Minisforum BD790i and it's variants in Fractal Ridge case

Ocena
0 / 5
Polubienia
11
Pobrania
115
Wydruki
0
Wyświetlenia
1769
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Share Alike

I wanted to optimize airflow for the BD790i inside my Fractal Ridge case. Played around with different fans and found out that the big NF-A15 and - even better - the newer NF-A14x25r do fit nicely in that setup. The new one even without any need to apply soft force.

To further optimize the airflow I wanted to install a fan duct to allow for direct fresh air intake (push config) or direct hot air release (pull config) through the side panel.

Found the nice model by Onkeldom (Thanks a lot!) on Cults3d and started to mod it to my needs.
 

Hints for printing and using:

  • It is advised to use some more heat resistant filament like PETG to prevent deformation after prolonged full load use, especially in pull config.
  • The model is adapted to fit nicely in the above mentioned setup. You just snap the holes over the screwheads and it should snap right in. If not, loosen the screws just a bit to make it snap and tighten them again afterwards. 

Tagi