1 / 2
Fan duct for Noctua NF-A15 and NF-A14x25r on Minisforum BD790i and it's variants in Fractal Ridge case — image 1
1 / 2

Fan duct for Noctua NF-A15 and NF-A14x25r on Minisforum BD790i and it's variants in Fractal Ridge case

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Fan duct for Noctua NF-A15 and NF-A14x25r on Minisforum BD790i and it's variants in Fractal Ridge case

Rating
0 / 5
Likes
11
Downloads
115
Makes
0
Views
1,769
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Share Alike

I wanted to optimize airflow for the BD790i inside my Fractal Ridge case. Played around with different fans and found out that the big NF-A15 and - even better - the newer NF-A14x25r do fit nicely in that setup. The new one even without any need to apply soft force.

To further optimize the airflow I wanted to install a fan duct to allow for direct fresh air intake (push config) or direct hot air release (pull config) through the side panel.

Found the nice model by Onkeldom (Thanks a lot!) on Cults3d and started to mod it to my needs.
 

Hints for printing and using:

  • It is advised to use some more heat resistant filament like PETG to prevent deformation after prolonged full load use, especially in pull config.
  • The model is adapted to fit nicely in the above mentioned setup. You just snap the holes over the screwheads and it should snap right in. If not, loosen the screws just a bit to make it snap and tighten them again afterwards. 

Tags