Creality K2 Plus Extruder PTFE M10 Pneumatic Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Support your K2 Extruder's PTFE tube from above the stock Pneumatic Connector using a M10 pass-through Pneumatic
- Ocena
- 5 / 5
- Polubienia
- 60
- Pobrania
- 524
- Wydruki
- 1
- Wyświetlenia
- 3777
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a work-around for those Creality K2 Plus owners who experience a failure in their extruder's PTFE tube's Pneumatic connector such that it stops holding your PTFE tube. You can use this with an M10 Pneumatic connector that will allow the PTFE tube to pass completely through all the way down to the bottom of the stock extruder's Pneumatic connector.
Recommended to be printed with a filament that can handle some heat, such as ABS.
You'll also need a 25mm M3 bolt for the left side of the part and a 8mm M3 bolt for the right side.
Major, enormous thanks to eth0whelm for creating 90%+ of this model, here: https://makerworld.com/en/models/1020734?from=search#profileId-1002016