(Remix) Tracer 9 GT Chain Slack Jig
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Slight remix to measure to the center of the chain as per manufacturer instructions
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 83
- Wydruki
- 0
- Wyświetlenia
- 383
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I really loved the original idea, so simple and effective. But I noticed the OG measures from the chainguard down to the top of the chain. Yamaha manual instructs you to measure 45-50mm to the middle of the chain while pushing down on it.
I adapted the 46mm design to measure the correct distance.
The 3D printed spring tensions the chain down, instead of having to push the chain down with a finger. Adjust the chain tension until the edge of the side pieces lines up with the center of the chain.
Printing instructions:
Prints with tree supports on buildplate only.
Use PETG as PLA is too stiff and will likely crack (at the spring)