1 / 2
Gridfinity 1x1 Sealing Flux Syringe Holder with optional extra tip holder — zdjęcie 1
1 / 2

Gridfinity 1x1 Sealing Flux Syringe Holder with optional extra tip holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Holds an Amtech flux syringe (or any other syringe with ~19mm diameter) with the syringe tip attached and sealed.

Ocena
0 / 5
Polubienia
6
Pobrania
43
Wydruki
0
Wyświetlenia
174
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This 1x1 Gridfinity bin is designed to hold a flux syringe for quick access. Unlike other models I could find, it seals the bottom of the hole to prevent leaks and keeps the flux from drying out.

The bin comes in four variants based around two different syringe needle tip lengths and the presence of storage holes for extra needle tips.

No special considerations for printing are needed. I had good results with standard PLA, a 0.4mm nozzle and 0.2mm layer height. If you want to enable ironing, I recommend using a modifier volume to only enable it for the large flat surface on the top. Something like the following position and size work for the short variant:

I found that adding a bit of silicone or other rubbery material (that is not dissolved by the flux) to the bottom of the hole aids in reducing flux leakage. This can be a small chunk cut out from something else (I used an old silicone soldering mat) or a small amount of RTV silicone.

Tagi