Combined BLTouch and Probe Mount (Step and Fusion360)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a combined BLTouch and Probe mount that includes a BLTouch protector. It will be referenced in future designs.…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 335
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a combined BLTouch and Probe mount that includes a BLTouch protector. It will be referenced in future designs. In case you want to modify the design or create your own fan duct around it, it's available as a STEP and Fusion360 file. If you decide to modify it, please post it as a remix!
BLTouch Protector V1_1 features a bigger diameter hole for the probe pin to deploy without interfering with the protector and a chamfer at the bottom to avoid the need of supports there!
The design was made using measurements for the Antclabs BLTouch V3.1 and a standard 18mm diameter probe!
For assembly you need 2x M3x20 screws + 2x M3 washers + 2x M3 nuts for the bltouch,
2x M3 grub screws for the probe,
1x M3 washer + 1x M3x8 screw for mounting the BLTouch protector and
2x M3x8 screws to mount the assembly to the fan duct.
Print Settings
Printer Brand:
Creality
Printer:
CR-10
No
Supports:
No
0.2
Infill:
15-25%
Category: 3D Printer Accessories