1 / 3
Herman Miller Aeron (2015) Armrest Articulating Arm Mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made this to mount my Svalboard to my Aeron. Requires minor mod to the armrest but is backwards compatible with…
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 1261
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (14)Powiązane
Made this to mount my Svalboard to my Aeron. Requires minor mod to the armrest but is backwards compatible with different screws.
BOM:
- 2x M6 Threaded Inserts
- 1x 1/4" Threaded Inserts (Model supports up to 5 positions)
- 2x M6x30 BHCS
- 2x M6 Washer
Instructions:
- Remove armrest pads
- Drill out both threads in the armrest pad with a 5/16" bit. No need to go beyond the original depth.
- Insert M6 threaded inserts into the holes drilled out in the step above.
- Insert 1/4" threaded insert into desired position in the printed part. You can install all 5 if desired.
- Place both M6 screws into printed part and hold against armrest bracket.
- Add in the M6 washers on the top side of the bracket. These will ensure weight is placed onto the M6 threaded insert and not the armrest pad itself.
- Put armrest pad in place and thread in both M6 screws loosely before tightening.
- Use your 1/4" articulating arm of choice!
Links:
- https://www.amazon.com/dp/B0CS6YCWHD
- https://www.amazon.com/dp/B0CZPD55C1
- https://www.amazon.com/dp/B0D1JTMMY1
- https://www.amazon.com/dp/B0BXCTRN7F
- https://www.amazon.com/dp/B088NRLMPV
Category: Other