1 / 3
E-Bike Charger holder for Ampler Bike Charger
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall holder for the ampler e-bike charger. Use a little metal plate to let the connector snap to the wall.
- Ocena
- 0 / 5
- Polubienia
- 26
- Pobrania
- 91
- Wydruki
- 0
- Wyświetlenia
- 881
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (1)Kolekcje (38)Powiązane
The charger for my Ampler bike was always lying in the way, also could get wet when snow melts, so I built this holder. I screwed a little iron plate next to it on the wall so the the charging connector can snap to it magnetically.
I printed with PETG, but I guess PLA would be sufficient.
I used the 0.2mm quality setting. Print standing upright then no supports are needed.