1 / 1
Tesla Cybertruck one part base and one part top — zdjęcie 1

Tesla Cybertruck one part base and one part top

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I was having a hard time getting my printer to print the base and top parts without any warping so I decided to print…

Ocena
0 / 5
Polubienia
4
Pobrania
59
Wydruki
0
Wyświetlenia
392
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Vehicles
Licencja
Creative Commons — Attribution

I was having a hard time getting my printer to print the base and top parts without any warping so I decided to print these parts as one. Now the ugly warped seams between the parts is gone!

I used the following parts to build the combined parts:

  • black_chassis_front.stl 01-12-20
  • black_chassis_rear.stl 01-19-20
  • silver_body_rear.stl 01-19-20
  • silver_body_front.stl 12-23-19
  • silver_rear_hatch.stl 12-23-19

Notes on Printing. I used Cura 4.4 for my slicer.

Cybertruck_Black_Base_One_Part.stl

  • Rotate part 80 degrees to get the rear bumper flat against the printer bed.
  • Using support blocker create a blocker that goes down to the top of the read wheel well.
  • Enable supports everywhere. I bumped up the default support density to 40%.
  • Enable raft, you might want to reduce the air gap between the part and the raft to get better adhesion to the raft.
  • I combined the parts using meshmixer and then in tinkercad.com I removed the humps for the screws and inserts.

Cybertruck_Silver_Body_One_Part

  • Rotate part -80 degrees to get the tailgate flat against the printer bed.
  • No need for supports.
  • No need for a raft.
  • I used a brim to help hold down the part.
  • I combined the parts using meshmixer.

Category: Vehicles

Tagi