1 / 1
Tesla Cybertruck one part base and one part top
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I was having a hard time getting my printer to print the base and top parts without any warping so I decided to print…
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 60
- Makes
- 0
- Views
- 394
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Vehicles
- License
- Creative Commons — Attribution
I was having a hard time getting my printer to print the base and top parts without any warping so I decided to print these parts as one. Now the ugly warped seams between the parts is gone!
I used the following parts to build the combined parts:
- black_chassis_front.stl 01-12-20
- black_chassis_rear.stl 01-19-20
- silver_body_rear.stl 01-19-20
- silver_body_front.stl 12-23-19
- silver_rear_hatch.stl 12-23-19
Notes on Printing. I used Cura 4.4 for my slicer.
Cybertruck_Black_Base_One_Part.stl
- Rotate part 80 degrees to get the rear bumper flat against the printer bed.
- Using support blocker create a blocker that goes down to the top of the read wheel well.
- Enable supports everywhere. I bumped up the default support density to 40%.
- Enable raft, you might want to reduce the air gap between the part and the raft to get better adhesion to the raft.
- I combined the parts using meshmixer and then in tinkercad.com I removed the humps for the screws and inserts.
Cybertruck_Silver_Body_One_Part
- Rotate part -80 degrees to get the tailgate flat against the printer bed.
- No need for supports.
- No need for a raft.
- I used a brim to help hold down the part.
- I combined the parts using meshmixer.
Category: Vehicles