1 / 6
DIY Filament Dryer 9733 Fan Duct and PTC heater mount. — zdjęcie 1
1 / 6

DIY Filament Dryer 9733 Fan Duct and PTC heater mount.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Fan Duct and Heater mount for 9733 fan and 100W PTC heater

Ocena
0 / 5
Polubienia
7
Pobrania
62
Wydruki
0
Wyświetlenia
851
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v2.0

This is a fan duct and ptc heater mount for a diy filament dryer using 9733 fan and a rectangular PTC heater. These parts are widely available on online platforms. The fan is 12V 0.6A and is marketed as 2.4A used as barbecue or used oil stove blower. PTC heater can be 12V or 220V at 100W and can easilly heat up to 95 degree Celcius(heater surface) with the fan at 50% power. The duct is designed be mounted from outside the box, fan inlet takes in air from the internal top part of the box, blows it through the heater and is directed to the bottom part of the box. it can also be mounted to the inside of the box with some mirroring and a bit of imagination. 2-4 heat set inserts are needed for mounting the heater to the duct, you will also need 4 pcs of m3x10 for mounting the duct and 2 pieces of m3 x 40  for mounting the fan to the box. Take the necessary precautionary and safety measures when designing the electronics side of things and do not burn your house down. 🤣

I only released the step files so you can modify it as much as you want.

Tagi