Hose Clamp / Clip – 10 mm to 38 mm – Washing Machine, Garden, Aquarium & More

Hose Clip / Clamp Range – 10 mm to 38 mm – Washing Machine, Garden, Aquarium & More

A simple, reliable hose clip for a wide range of common household hoses and tubes. Originally designed to secure a washing machine or dishwasher drain hose to a standpipe, sink, cabinet or laundry tub so it can't kick loose mid-cycle and flood the floor — but it works equally well for garden hose, aquarium and pond tubing, irrigation, vacuum hose, pool/spa hose and just about any similarly sized tube around the home or workshop.

This listing covers a full family of sizes so you can match the clip to your hose. Each size also comes in a standard (short) and a long version for extra grip on awkward or heavier hoses.

For extra peace of mind, every clip includes built-in cable-tie channels so you can lock the hose in place. In most cases the clip alone holds fine, but the channels are there when you want belt-and-braces security. Each clip is designed to be glued, siliconed or double-sided taped to a flat surface, and also includes a countersunk screw hole (x2 on long versions) for a solid screw-down option.

📏 Size Guide

Each clip is sized to the outer diameter (OD) of your hose. Every size includes 0.5 mm clearance on top of the advertised nominal size, so the clip snaps on cleanly rather than fighting the hose. Measure your hose's outer diameter and pick the closest nominal size.

📐 Length Versions

Every size is available in two lengths:

• Standard / Short – 30 mm long. The everyday choice for most hoses. Quick to print and uses less material.

• Long – 50 mm long. More contact area along the hose for extra grip — handy for heavier, stiffer or more awkward hoses, or where you want maximum hold against pop-off.

✅ Features

• Full size range: 10, 13, 16, 19, 20, 22, 24, 28, 32 and 38 mm (OD)

• 0.5 mm clearance built into every size for a clean clip-on fit

• Two lengths per size — standard (30 mm) and long (50 mm)

• Ideal for washing machine and dishwasher drain hoses, plus garden, aquarium, pool and vacuum hose

• Optional cable-tie channels for extra hold against pop-off

• Countersunk screw hole for screw-down mounting, plus glue / silicone / double-sided tape options

• Quick, easy print — settings are not critical

• Original design

🖨 Recommended Print Settings

💡 Print settings aren't critical here — most materials and profiles will work. PETG was used for moisture resistance, durability and slight flex, which suits a laundry, outdoor or aquarium environment. TPU and ASA would be very good options as well.

🔧 Installation

1. Measure your hose's outer diameter and choose the matching nominal size.

2. Pick the standard (30 mm) or long (50 mm) version for the grip you want.

3. Print end down — no supports needed.

4. (Optional) Affix to a flat surface with glue, silicone, tape, or a countersunk screw.

5. Clip onto the hose at the point you want to secure.

6. (Optional) Run cable ties through the channels and tighten for extra security.

🚿 Compatibility

• Hoses/tubes/pipes from 10 mm to 38 mm outer diameter (see size guide)

• Washing machine and dishwasher drain hoses

• Garden hose, drip irrigation

• Aquarium and pond tubing

• Vacuum cleaner and central vacuum hose

• Pool / spa hose, sump pump and caravan/RV waste hose

If you printed one, a quick make or photo is always appreciated!