JST-XH mounts for 2020 rail
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount JST-XH connectors to a 2020 extrusion - making tidy wiring!
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 376
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
A simple printed mount for three 2-pin, or three 3-pin, JST-XH connectors. I used one to keep the fan wiring under my Voron Trident bed tidy. Then I could run a single fan power cable up from the electronics bay, and have connectors for each bed fan.
Print standing on end (as shown in CAD picture), as this way you won't need supports!
Solder together the three connectors, taking care to keep them tight and aligned. This assembly will then slide nicely into the print. It is a friction fit - but not so much it wont come back out or make the connectors difficult to disconnect.
Mount to the extrusion using an M3 screw and a tee nut.