Bento Backpack for Voron 2.4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple two-piece frame for the BentoBox to attach to the back of your Voron 2.4.
- Ocena
- 0 / 5
- Polubienia
- 24
- Pobrania
- 62
- Wydruki
- 1
- Wyświetlenia
- 819
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Bento Backpack is a fan duct mod for thrutheframe's awesome BentoBox v2.0.
Motivation
I wanted to add a HEPA filter to my Voron 2.4 printer, as I currently only use Carbon filters under the heated bed. Since I use the BentoBox filter in my other printers, I decided to follow the same route.
Frame Bottom
I divided the original fan duct into two sections, enabling each fan to operate separately and channel airflow through its own dedicated duct. Furthermore, the two vertical air ducts are fully enclosed and seamlessly integrate with the Voron ventilation grille.
Frame Top
Following the original design approach, it attaches to the bottom section using four magnets. The reinforced corners sits on top of the vertical air ducts, providing added stability. Additionally, I positioned the original Voron PTFE tube inlet at the center of the top section.
Print Settings
- Layer height: 0.2mm
- Infill percentage: 15%
- Supports: None
BOM
- 8 x Magnets (Ø4mmL2mm)
- 6 x M3 heat set inserts