Strong Ahh Hook
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a strong hook. I made them to hold my guitars and other things.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 200
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution
This is a strong hook. I wanted to design a strong hook that doesn't use too much filament. I tested it up to 50 lbs in a very scientific test.
It did make some concerning noises at 50 lbs so I would recommend less than 40.
I printed mine in PLA with 10% infill and 6 walls. It is meant to be printed in the orientation the model is in. At an angle for max stronk.
You will most likely need brim to keep it upright, but NO supports. I used 6mm of brim.
This is a strong hook, but please be mindful of hanging expensive things on them. I use mine for my guitars, but I also have tested mine and how my printer printed it. Your results may very.