1 / 3
Voron Bowden ptfe tube guide arm 1mm spring steel wire extension clips — zdjęcie 1
1 / 3

Voron Bowden ptfe tube guide arm 1mm spring steel wire extension clips

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Clips that connect to the 1mm spring steel wire that attached to the guide arm allowing the arm to be extended and flex.

Ocena
5 / 5
Polubienia
18
Pobrania
56
Wydruki
1
Wyświetlenia
955
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

Clips that attach to the 1mm spring steel wire that is mounted on the guide arm. Allows you to extend the length of the guide arm to keep the PTFE tubing up and out of the way yet creating the flexibility it needs to not collide or get caught on anything else in the upper chamber. 2 sizes available: 4.5mm ID for plain PTFE 4mm OD and 6.5 mm ID if the tubing is covered in wire loom. 

Print with standard Voron settings probably in ABS or ASA. 

The hole for the wire to go through is 1.5mm but will be tight after it is printed. I clipped a small piece of the 1mm spring steel wire off at an angle and put it in a pin vice to use sort of as a drill just to stretch it a bit. You do however want the clip to be quite tight on the wire so It doesn't slide.

Tagi