HGX Lite Extruder Cooling Fan with Optional Thermistor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Keeping the HGX Lite Cool during longer prints to stop jams due to softened filament.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 229
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
Although it is just fine for the extruder motor in direct drive to run hot, it will, thats what it does. The problem is that the HGX Lite extruder (all metal) is a great heatsink for the motor, so it gets very hot too. When it is hot enough, usually during longer prints, the filament can soften to the point that the extruder can no longer drive it, it just bungs up the extruder causing a full dismantle to get it fixed, not to mention the failed print you gained as a result. The fan it takes is any 4010, in my case 24v, it has a connection block (for adding a 2 pin header) so that it can be removed with ease. Although you don't need a Thermistor to run this, it is good to know how effective it is in cooling your motor. The thermistor option will take a bit of work, depending on your exact motor, mine was made for the motor that came with my HGX Lite, you need to make sure that the thermistor is running through the hole and is then held up against the motor itself to read the temperature. The fan is mounted to maximise airflow over the HGX itself rather than the motor, the HGX being the motors heatsink makes this preferrable, rather than trying to cool the motor itself. My klipper code (for my Manta M8P) is as follows;
[temperature_fan HGX Lite]
pin: PA4
max_power: 1.0
shutdown_speed: 0.0
kick_start_time: 5.0
cycle_time:0.01
off_below:0.1
sensor_type: Generic 3950
sensor_pin: PC4
min_temp: 0
max_temp: 70
target_temp: 50.0
control: watermark
gcode_id: C
Can't remember where I got the code from, but this kicks it in when the motor is above 50 deg, I just finished this so the operation of it has not been fully tested, but at least the code might help someone get started too.
I printed this in ABS, but would work fine in any filament. Print with the fan housing bottom down and use support (sorry about that). You will need 2 x 45mm screws, the HGX is already threaded where this fits. I did make this with a deeper fan base to take 5mm brass inserts, but when I fitted the fan it was a nice tight fit so I changed the model to do without the brass inserts and corresponding bolts to keep weight down, similarly no fan cover as it is pretty much superfluous.
