Volvo 1059366 Rubber Mount for Engine Cover

I have access to two Volvo V70 where one out of four of those rubber mounts is missing funny enough it's in the same location on both cars. I first had a look at the model from @jeveli . However that model was several millimeters smaller than the still existing original rubber mounts. After some searching it looks like for the different V70 models and their different engines exist different rubber mounts.

I'm not sure which other car models this 3d model fits but at least I know it fits on my Volvo V70 (2009) with motor type D5244T4, I believe the original Volvo part number is 1059366.

I have no long term test results yet if the TPU survives the closeness to the engine.

Changelog

• 2025-02-04: Uploaded first public revision R2.

Useful measurements

• Metal stud
  • Ball diameter: 15mm
  • Shaft diameter: 10mm
• Rubber mount
  • Outer diameter: 31.75mm
  • Wall height: 18mm
  • Overall height, including "dome": 20.85mm
  • Minimum opening width for ball: 13mm
  • Material used: 9.3g

Printing

• Material: I used “Das Filament” TPU 94A, it's a bit stiffer than the original but that could be because the old rubber mount is worn out.
• Nozzle: 0.4mm
• Layer height: 0.2mm
• Infill: 15%, Gyroid
• Perimeters: 3
• Supports: I painted on supports only for the outer wall overhang, see picture.
• Orientation: Like the model is oriented.