1 / 3
Large Diameter Shipping Tube Rocket Nose Cone (75mm INT - 81mm EXT) — zdjęcie 1
1 / 3

Large Diameter Shipping Tube Rocket Nose Cone (75mm INT - 81mm EXT)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a large diameter rocket nose cone to make a rocket out of a shipping tube.

Ocena
0 / 5
Polubienia
5
Pobrania
34
Wydruki
0
Wyświetlenia
150
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Engineering
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

This rocket nose cone was designed to fit a shipping tube. I'm not sure if there are standard sizes for these, so please measure before printing. The file is labeled for the measured internal (INT) and external (EXT) diameters of the tube. The internal diameter will print 1mm smaller for a tight tolerance on the tube. If you measure the internal diameter of your tube and it is 75mm, you should use this file, but the diameter will print to 74mm so it can fit in the tube. Inside the collar of the nose cone there's a hole to tie off the parachute cord. I like to connect fishing snap swivels to these to help prevent the cord from tangling up.

Printing instructions: The model should be printed upright with supports enabled on the build platform to support the overhang around the rim. I printed mine in PLA at 0.25mm STRUCTURAL with 10% Gyroid infill and it turned out great. I usually give them a light sanding and clean up the point after taking them off the printer.

Tagi