BXA Lathe Quick Change Tool Holder Interlocking
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Interlocking BXA Lathe Tool Holders, Left / Right / Large Right, designed for my Shop Fox Lathe similar to Grizzley.
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 157
- Wydruki
- 1
- Wyświetlenia
- 768
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
I designed these tool holders to move the tool a little more above the edge of the splash guard. I also wanted these to interlock with each other without the use of any hardware. These fit the BXA size quick change tools and the model is designed to fit my Shop Fox lathe which is very similar to a Grizzley. Check the splash guard dimensions to your own, dimensions shown in photo. Rather simple to adjust if needed.
There are two sizes for the ‘Right Side’ holder. This points the tool away from you for most uses. If you're OCD like me, I created a ‘Left Side’ tool holder also, although only required if you want the opposite direction tools to away also. There is a ‘Right Side Large’ holder which fits the wider tool usually found with parting tools. It is 1.5" wide vs 1.2" wide for the standard holder.
The Left Side holder will require support material where as the Right Side holders do not. I printed mine in PETG and had great results.