TwoTrees Sk1 Set of centering and dust-protective sleeves for thrust bearings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Reduce the load on the stepper motors in SK1 printer by using F8-16M thrust bearings.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 399
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I decided to reduce the load on the stepper motors in my SK1 printer by using F8-16M thrust bearings (8x16x5 mm). To ensure proper installation, I added centering rings, allowing the bearings to stay perfectly aligned with the lead screws. Additionally, this setup provides protection against dust and filament debris entering the bearings.
Print Settings:
- Material: ASA
- Layer height: 0.2 mm
- Nozzle: 0.4 mm
Note: My TwoTrees SK1 is well-calibrated, ensuring excellent dimensional accuracy with tight tolerances. Please consider this when printing.
Step 1: Printing All Components
Print the following parts before starting the assembly:
- 2 x Mounting Sleeves for Front Bearings
- 1 x Centering Ring Rear Z
- 1 x Sleeve for TH Bearing Rear Z
Step 2: Front Z-Axis Bearings Assembly
- Press the bearings into the mounting sleeves and ensure they rotate freely.
- Unscrew the lower part of the lead screw coupler.
- Lift the coupler enough to insert the sleeve into the motor housing.
- Tighten the coupler securely.
- Repeat the process for the other front Z-axis.
Step 3: Rear Z-Axis Bearing Assembly
- Remove the rear lead screw coupler.
- Place the Centering Ring Rear Z onto the protruding body of the stepper motor.
- Gently position the Sleeve for TH Bearing Rear Z into the centering ring.
- Ensure the components fit snugly.
Step 4: Gluing Components (Optional)
To ensure a perfect fit and stability, I recommend gluing the centering ring and sleeve after seating them. While it’s possible to glue them beforehand, ensure a 0.5 mm gap between the ring and the sleeve's lower part. Tamiya Extra Thin Cement works perfectly with ASA and provides a strong bond.
Final Steps:
- Tighten all components securely.
- Level the print bed.
- Enjoy smoother and lighter operation of the stepper motors!