Archetype Toolhead (Experimental Branch) for Ender Belts (w MGN9 rails)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Belt clips and X Endstop pusher for Ender belt path (Belt above and below the extrusion).
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 572
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Archetype toolhead (Experimental Branch) for Ender belt path. Requires MGN9 rail on the X gantry, see this for a no rails version
Updated version of this, for the Archetype Experimental branch.
Belt mount & belt mount end: updated belt mounts for an Ender type belt path (belt going over and under the extrusion). This new version is intended for the Archetype MGN9 rail mounts.
X endstop: This is an adjustable X endstop pusher that mounts where Archetype's belt clips would usually go. It uses a square nut to attach an M3 bolt, and a second square nut as a hard stop to let you torque it securely without deforming the plastic. It has also been tweaked to better fit the shape of the mount, so it shouldnt wiggle as easily.
Dragonfly Base: a mount for the Phaetus Dragonfly BMO. 2x MZE aligns the hotend length with that of a medium hotend.
Extra BOM:
Endstop pusher:
2x M3 square nuts
1x M3x16 SHCS (adjust bolt length to taste)
Belt Clamp:
2x M3x50 full thread SHCS/BHCS (or partial thread M3x50 if you dont add the bottom heatsets on the rail mounts)
2x M3x16 BHCS
4x Heatset
Dragonfly Base:
2x MZE
4x M2.5 SHCS (comes with the BMO)