Holder for Vessel electric screwdriver for pegboard or wall mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds the Vessel electric screwdriver close to a wall, either pegboard or a standard wall.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 69
- Wydruki
- 0
- Wyświetlenia
- 213
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Holder for the Vessel electric screwdriver. Holds it close to the wall, and slightly tilted out (5 degrees) in order to clear the ball head, but still allow a longer bit to not run into the wall.
I picked up the Vessel based on a recommendation by Dave Rome - if you don't follow him on Instagram and read his articles on Escape Collective - and you like bike tools, you really should. The Vessel was listed in his “My Favorite Things of 2023” article. It's a really nice little screwdriver and works well for many bike fasteners.
See also this version by fellow Escape Collective member BKJeane3 for a different take on the same holder.
Prints without supports, and the screwdriver is light so default settings are likely fine. The pegboard version can print without supports, with a little cleanup needed of the top pegs after printing, or you can use supports off the print bed. Your call, I've done both with good results.
I printed in silk red to match the accent ring at the top of the tool.