Holder for Vessel electric screwdriver for pegboard or wall mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holds the Vessel electric screwdriver close to a wall, either pegboard or a standard wall.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 69
- Makes
- 0
- Views
- 213
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Holder for the Vessel electric screwdriver. Holds it close to the wall, and slightly tilted out (5 degrees) in order to clear the ball head, but still allow a longer bit to not run into the wall.
I picked up the Vessel based on a recommendation by Dave Rome - if you don't follow him on Instagram and read his articles on Escape Collective - and you like bike tools, you really should. The Vessel was listed in his “My Favorite Things of 2023” article. It's a really nice little screwdriver and works well for many bike fasteners.
See also this version by fellow Escape Collective member BKJeane3 for a different take on the same holder.
Prints without supports, and the screwdriver is light so default settings are likely fine. The pegboard version can print without supports, with a little cleanup needed of the top pegs after printing, or you can use supports off the print bed. Your call, I've done both with good results.
I printed in silk red to match the accent ring at the top of the tool.