1 / 7
ProPel Endeavor 2/3 Rear Fenders (Replaces Belt Guard) — zdjęcie 1
1 / 7

ProPel Endeavor 2/3 Rear Fenders (Replaces Belt Guard)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Here is a pair of rear fenders for the Endeavor 2/3. Updated W/belt fender and over fenders!

Ocena
5 / 5
Polubienia
4
Pobrania
53
Wydruki
2
Wyświetlenia
265
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Sports
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Here is a pair of rear fenders for the Endeavor 2/3! They replace the OEM belt guards! You can use the OEM hardware if desired, but personally, I use a slightly longer set of screws (about 5mm extra) with a washer on the back of each.  Access to the screws is tight; I still use Allen head screws, so I'm able to use the short end of the Allen tool or an Allen head with a wobble end. 

In the update, I've added belt fenders and a slight overfender as part of the assembly. I found that when riding, my back pant leg would still get a little wet. Water would accumulate on the belt and belt hub, accumulating on my back pant leg. This update fixes this issue. If you are just looking for fenders, the old files are still in here. 

PRINT SETTINGS that I use (X1C)

  • .2mm resolution 

  • support - yes

  • 4 layer wall

  • 5 later roof and base

  • 15% cubic infill

Tagi