1 / 3
Desk stand replacment for a lamp
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed as a replacement for a stand that bolts to the side of your desk.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 81
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
It can hold a lamp, microphone, and everything else that has a mounting “clamp” to the desk and has a rod that slots into the mount. Ideally should be printed in PETG, although if your lamp is light, PLA could work too. For PLA I recommend an increased infill (30 % or more, depending on filament, 50% should be more than enough)
Printing instructions:
- PLA, or any other material (PLA works very well for me),
- No supports,
- Infill on the higher side (My: 30% gyroid),
- Brim not required but recommended,
If you have questions, ask in the comments. If this model suits your needs remember to like. I would also very appreciate if you upload a make.