IKEA Svalnas Rear Bracket Replacements with 10-32 Bolt Pin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Redesigned from the original steel parts to use an Imperial #10-32 * 1/2in bolt for strength
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 158
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Public Domain
This hardware is no longer available from IKEA as spare hardware because Svalnas shelving has been discontinued. I picked up a load for cheap locally and was missing some hardware.
I needed the pin to bear some more shearing force and the original rambonbinator models weren't strong enough printed in the L configuration, rear side down relying on the pin shearing force just on layer adhesion.
I redesigned in 2 separate pieces to use a standard 10-32 * ½ inch bolt.
Standard in the US available in small packs for about $1.50 in every home improvement store.
Take a button head / dome head 10-32 * ½ inch bolt, chuck it in a drill held by the threads (ok if threads get damaged a little), and grind / sand the driver head down to 1.0-1.3 mm. (Nominally 3.0mm factory head thickness).
I made 6 of them personally with a bench grinder and Vernier caliper in under 10 mins.
Glue the modified bolt into the bracket under the head with Superglue / CA glue.
CA glue the threads into the Tube print as a sheath over the threads to hold the bolt to the bracket while glue dries.
Print 100% infill.
Enjoy strong brackets.