IKEA Svalnas Rear Bracket Replacements with 10-32 Bolt Pin
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Redesigned from the original steel parts to use an Imperial #10-32 * 1/2in bolt for strength
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 28
- Makes
- 0
- Views
- 160
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Public Domain
This hardware is no longer available from IKEA as spare hardware because Svalnas shelving has been discontinued. I picked up a load for cheap locally and was missing some hardware.
I needed the pin to bear some more shearing force and the original rambonbinator models weren't strong enough printed in the L configuration, rear side down relying on the pin shearing force just on layer adhesion.
I redesigned in 2 separate pieces to use a standard 10-32 * ½ inch bolt.
Standard in the US available in small packs for about $1.50 in every home improvement store.
Take a button head / dome head 10-32 * ½ inch bolt, chuck it in a drill held by the threads (ok if threads get damaged a little), and grind / sand the driver head down to 1.0-1.3 mm. (Nominally 3.0mm factory head thickness).
I made 6 of them personally with a bench grinder and Vernier caliper in under 10 mins.
Glue the modified bolt into the bracket under the head with Superglue / CA glue.
CA glue the threads into the Tube print as a sheath over the threads to hold the bolt to the bracket while glue dries.
Print 100% infill.
Enjoy strong brackets.