1 / 2
Fractal 75 3d printed ducts (from F75 pro max ducts) — zdjęcie 1
1 / 2

Fractal 75 3d printed ducts (from F75 pro max ducts)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

3d printed Fractal 75 ducts based off the Pro Max ducts

Ocena
4 / 5
Polubienia
12
Pobrania
47
Wydruki
1
Wyświetlenia
394
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

As stated in the differences section, this is a resized Pro Max Whoop 3d printed ducts to suit the standard 75 frame. I have been using the standard struts from the original page which may be putting the ducts a little high, but seems to work.

I have printed the ducts in PLA Plus and then printed the struts in TPU. The TPU seems to be just about stiff enough to support the duct sufficiently. Initially I printed the struts in PLA Plus too, but they didn't last that long.

When mushing down the tabs with a soldering iron (when joining the struts to the duct), I have found that if this is not done enough the props are sometimes clipping the attachment points.

Tagi