Fractal 75 3d printed ducts (from F75 pro max ducts)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3d printed Fractal 75 ducts based off the Pro Max ducts
- Rating
- 4 / 5
- Likes
- 12
- Downloads
- 47
- Makes
- 1
- Views
- 391
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
As stated in the differences section, this is a resized Pro Max Whoop 3d printed ducts to suit the standard 75 frame. I have been using the standard struts from the original page which may be putting the ducts a little high, but seems to work.
I have printed the ducts in PLA Plus and then printed the struts in TPU. The TPU seems to be just about stiff enough to support the duct sufficiently. Initially I printed the struts in PLA Plus too, but they didn't last that long.
When mushing down the tabs with a soldering iron (when joining the struts to the duct), I have found that if this is not done enough the props are sometimes clipping the attachment points.
