Desk Mount Headphone Holder FOR THIN DESKS (< 25 mm)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix to better fit thinner desks. It takes less space and should be more resistant.
- Ocena
- 5 / 5
- Polubienia
- 74
- Pobrania
- 575
- Wydruki
- 19
- Wyświetlenia
- 1656
- Oceny
- 17
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
The original model could fit desks up to 40 mm thick, which was way more than I needed.
So I shortened it a bit and now it can only fit desks thick less than 25 mm.
The pros are:
- Reduced printing times.
- Should be more durable thanks to a shorter torque arm.
- Less space is occupied under the desk.
— LOOK OUT!
- I redesigned the entire bottom clamp and the screw. The screw is not retro-compatible and you need to print my version or it won't screw in.
- The cable holder is reversed, so it faces the same way as mistertech's Headphone Holder.
—
I printed it at .24 mm layer height, and the screw turns without any problem. It doesn't have tight tolerances so you should be good printing it at even lower definition.