1 / 4
Portable 10 GHz Radio Housing — zdjęcie 1
1 / 4

Portable 10 GHz Radio Housing

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Housing designed to hold a Kuhne MKU 10 G5, 3 cm transverter

Ocena
0 / 5
Polubienia
0
Pobrania
12
Wydruki
0
Wyświetlenia
137
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Public Domain

This housing is designed to hold a Kuhne MKU 10 G5, 3 cm transverter, and a small horn antenna. Additionally, it features a slot for a Talentcell 3Ah battery. For the battery, a barrel connector on a cable is required to be glued into place to ensure proper alignment.

Brass, threaded heat-inserts are used to hold things together (4mm hole for 3mm screws). The bottom features holes for ¼-20" threaded inserts.

Antenna mounting within is left as an exercise to the reader, as it will depend greatly on antennas and waveguide transitions, etc.

I used 3mm walnut plywood for the front panel, but it can easily be 3D printed and customized to your particular interface/connector plans.

Tagi