Portable 10 GHz Radio Housing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Housing designed to hold a Kuhne MKU 10 G5, 3 cm transverter
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 12
- Makes
- 0
- Views
- 137
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Public Domain
This housing is designed to hold a Kuhne MKU 10 G5, 3 cm transverter, and a small horn antenna. Additionally, it features a slot for a Talentcell 3Ah battery. For the battery, a barrel connector on a cable is required to be glued into place to ensure proper alignment.
Brass, threaded heat-inserts are used to hold things together (4mm hole for 3mm screws). The bottom features holes for ¼-20" threaded inserts.
Antenna mounting within is left as an exercise to the reader, as it will depend greatly on antennas and waveguide transitions, etc.
I used 3mm walnut plywood for the front panel, but it can easily be 3D printed and customized to your particular interface/connector plans.