1 / 3
Qiditech PLUS 4 bowden tube clip to hold radius under glass — zdjęcie 1
1 / 3

Qiditech PLUS 4 bowden tube clip to hold radius under glass

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The Plus 4 machine has wear issues on the PTFE tube when using the glass lid. This clip will snap into position.

Ocena
5 / 5
Polubienia
11
Pobrania
94
Wydruki
0
Wyświetlenia
308
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This part is designed to clip into position above the bowden connector on a plus 4 3d printer to add a radius to the PTFE tube and hold it off the glass lid when used.

Testing has shown there is sufficient radius on the filament to allow no friction with clip in place.

Cable tie if needed on long end.

 

Print settings:

Recommended use with ABS or higher for heat tolerance.

If ABS allow for shinkage, I've set mine to 101.5% scale in ABS and works to 4.1 ID for tube route.

 

V4 has cable tie in case.

Layer: 0.15 min

Nozzle: 0.3 or 0.4mm

Supports: Yes on bed only

 

 

Tagi