1 / 3
s300 Hard Drive Mount — zdjęcie 1
1 / 3

s300 Hard Drive Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

2.5 inch hard drive mount for the s300 SFF case, have not tested but should be just enough clearance

Ocena
0 / 5
Polubienia
1
Pobrania
11
Wydruki
0
Wyświetlenia
83
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Was frustrated with the s300's silly SATA drive mount, where you need a shorter gpu to use it. Saw the 92mm fan was basically just blowing air into the cable side of the power supply and decided to make a 2.5" HDD mount for it.

Printed with PETG in Cura at default settings, but PLA might be fine.

Have not tested if it works, but its very little filament to print it.

Mount with m3 - m4 bolts. Preferably with a flat head so the dust filter can sit properly. I used these.