1 / 3
s300 Hard Drive Mount — image 1
1 / 3

s300 Hard Drive Mount

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

2.5 inch hard drive mount for the s300 SFF case, have not tested but should be just enough clearance

Rating
0 / 5
Likes
1
Downloads
11
Makes
0
Views
83
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial — Share Alike

Was frustrated with the s300's silly SATA drive mount, where you need a shorter gpu to use it. Saw the 92mm fan was basically just blowing air into the cable side of the power supply and decided to make a 2.5" HDD mount for it.

Printed with PETG in Cura at default settings, but PLA might be fine.

Have not tested if it works, but its very little filament to print it.

Mount with m3 - m4 bolts. Preferably with a flat head so the dust filter can sit properly. I used these.