MTD Canopy
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a canopy for MTD. Unfortunately I lost one during a flight, so I made this one. It's obviously a bit heavier,…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 237
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
This is a canopy for MTD. Unfortunately I lost one during a flight, so I made this one. It's obviously a bit heavier, but still acceptable.
Print Settings
Printer:
AM8 BLV
Rafts:
No
Yes
Resolution:
0.1375
around 5%
Notes:
I used:
6 top solid layers
3 bottom solid layers
1 perimeter shell
The canopy is placed flat on your printing bed, in the same position as it's installed on the plane.
You can glue the clip with CA.
It's hard to have a nice top layer finish with such little infill. YMMV.
I printed at 150mm/s and 40% solid infill underspeed.
Category: R/C Vehicles