1 / 6
Magnetic Door Catch for Printed Solid Enclosure
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Needed a better seal around the door. You can install as many as you like to press the door firmly against the panel.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 1
- Wyświetlenia
- 101
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Designed for 3mm thick panel and 9mm of clearance for panel overlap.
Important!!!!
- The following files require a pause at certain layer height to place hardware.
- DoorCatch DoorFront.3mf Pause at 2.80mm
- DoorCatch FrameBack Regular.3mf Pause at 4.00mm
- DoorCatch FrameBack Lowprofile.3mf Pause at 4.00mm
- Be sure to check magnet polarity when inserting mid-print.
- Magnets could get pulled up by steel nozzle or other metal parts. Do watch the print.
Hardware per set (Also see example photo)
- 4 of 10mmx2mm disk magnet
- 4 x M3 socket head screw with minimum length at 12mm
- 4 x M3 hex nut, 5.5mm width, 2.3mm thickness
How to use These files (See photos for side by side comparison)
- DoorCatch DoorFront.3mf
- Attach to acrylic panel. This is the only choice. Pause at 2.80mm height to insert magnets. Check polarity.
- DoorCatch FrameFront Lowprofile.3mf
- Pick one of the following two. This one offers 1mm more clearance to fit the door compare to the regular.
- DoorCatch FrameFront Regular.3mf
- Original design, same size as the backing piece (Frameback regular.3mf). Tighter fit with the door.
- DoorCatch FrameFront Jig.3mf
- A jig used to mark hole for drilling. Essentially the regular piece with a 1mm edge added. Thus it gives 1mm clearance when paired with the regular piece and 2mm clearance with the lowprofile
- DoorCatch FrameBack Regular.3mf
- Backing piece for both the DoorFront and the FrameFront. Insert a m3 nut at height 4.00mm with a pause midprint.
- DoorCatch FrameBack Lowprofile.3mf
- The vertical portion of the enclosure has no space to mount the full sized backing piece, thus this is created. Insert a m3 nut at height 4.00mm with a pause mid-print.
Feel free to leave suggestions