Liczymy pasujące modele…
A simple latch for the PrintedSolid Prusa next gen safety enclosure. This is a super easy print, with no supports needed, no glue, and just press-fit components. It just needs 2 neodymium magnets, 2mm thick and 10mm in diameter, available…
Yet another spool design, yet another spool support design. Thankfully, the new cardboard design allows for a minimal spool support. This one costs less than 16g (~8g each) of filament per spool. Printed with a 0.6mm nozzle at draft layer…
Jessie went to cardboard spools, either to save money or the planet or both, but the cardboard spools don't unwind that well and really need a bushing, so this is what this is. This may be overkill, but they stay on and work well.
PrintedSolid Jessie Cardboard Filament Spool Spacer support. Allows the spool to rest more evenly on the spool holder. EDIT: updated design files with chamfered edges and a very slight increase to diameter to create a more snug fit NOTE:…
This is an adaptor ring for the PrintedSolid Jessie PLA rolls to work with the RepWinder from Repkord. The Generic ring was just a bit too tall to work, so I shortened it up. Use the generic prusament base cap with this spacer and the…
This is remix that increases the outer diameter of the original design to accommodate changes in the Jessie spool design. Done in TinkerCAD. When the weight of the spool is supported by only half of the inner spool support, it tends to…
simple door latch that requires a 5mm countersunk screw and a 5mm nut that is embedded.
Another adapter for the printed solid Jessie spools now that they are moving to cardboard spools. I didnt want to miss out on using my repwinder for the most common spools I used, so I did a ton of remixing to make this work. You…
Same as Krisas Man's V8, but fitted to work with my Filament Passthrough https://www.printables.com/model/441260
Updated large hatch to hold power supply (PS) with shelf to hold PS, bolt on ‘strap’ to secure PS, and slot for wires to pass. Updated all hatches to have recesses for hex nuts, so that you can just insert screws into hatch from inside…
I downloaded and printed several of the latches on Printables and Thingiverse for the PrintedSolid enclosures, and none quite fit my needs. So, I made one to suit. These are oriented as I suggest printing. I use supports for the one with…
I was tired of the perch spool mount on my Pulse XE that would not let the PrintedSolid enclosure door close fully. I was inspired but the remaining spool arm left after I assembled my Original Prusa Enclosure, so I made this.…
