[BTT] Smart Filament Sensor mount and pass thru IKEA LACK table
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I've designed a mount for the smart filament sensor from BigTreeTech (BTT), so I can put a dry box on the ikea…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 760
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I've designed a mount for the smart filament sensor from BigTreeTech (BTT), so I can put a dry box on the ikea enclosure and feed the filament directly into my hotend.
What do you need:
Smart Filament Sensor from BigTreeTech (longer screws are in the box from BTT) *25mm hole/drill in the IKEA lack table I've designed in that way, that you screw the mount with the filament sensor on the pass thru. They both got a thread so you dont need anything else. It holds pretty good for me.
Please make sure that you print the thread in a small layer height (recommended: adaptive layer height, so you got a lower LH at the thread, and then a bigger one to save a lot print time).
### Installation
- print both parts
- remove 2 screws from the filament sensor (both middle ones)
- take the longer provided screws from BTT and mount it on the plate
- drill 25mm hole in the ikea table
- insert passThru
- cut PTFE tube to needed length
- align the mount on the passThru, make sure the PTFE tube comes out
- screw the mount carefully on the passThru,do not overtighten, or you'll break the thread
Category: 3D Printer Accessories