ESP-12E/F, CB3S Programmer Jig (Pogo Pins)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple programmer jig for ESP-12E, ESP-12F, and CB3S using pogo pins. May work with others too
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 100
- Wydruki
- 0
- Wyświetlenia
- 621
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
I needed a way to program a Tuya CB3S chip without removing it from the PCB, and didn't want to solder if I didn't have to. So I made a jig that uses 1mm pogo pins.
Print this in whatever filament you want (I used simple PLA) then hand-drill the holes for whichever pins are needed for programming using a 1mm bit. Press-fit the pogo pins so they stick out a few mm, solder or clip wires to the pins, and use a clamp for hands-free if you want.
This should work with ESP-12E, ESP-12F, and Tuya CB3S boards. I haven't tried others but they might also work