ESP-12E/F, CB3S Programmer Jig (Pogo Pins)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple programmer jig for ESP-12E, ESP-12F, and CB3S using pogo pins. May work with others too
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 100
- Makes
- 0
- Views
- 621
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
I needed a way to program a Tuya CB3S chip without removing it from the PCB, and didn't want to solder if I didn't have to. So I made a jig that uses 1mm pogo pins.
Print this in whatever filament you want (I used simple PLA) then hand-drill the holes for whichever pins are needed for programming using a 1mm bit. Press-fit the pogo pins so they stick out a few mm, solder or clip wires to the pins, and use a clamp for hands-free if you want.
This should work with ESP-12E, ESP-12F, and Tuya CB3S boards. I haven't tried others but they might also work