One piece snappable pin header sizing tool. 2, 3, 4, 5, 6+7, 8+9, 10+11, and 12+13 position
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This tool makes it easy to size snappable pin headers into any length between 2 and 13 pins. No fasteners required!
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 198
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a tool to quickly size a snappable pin header to a desired length (2 to 13 pins). It is for standard 0.100" (2.54mm) pitch pin headers.
I've been using arturo182's pin header break away tool for many years – this is clearly inspired by his original design (https://www.printables.com/model/180816-pin-header-break-away-tool)
I created my own design that works for all lengths between 2 and 13 pins. I also wanted it to easily fit into the pocket of a 2x-wide Gridfinity tool holder that I use.
For best results, print on a raft if your printer tends to knock over tall prints. No supports needed.
In the photo, I sanded down the numbers to make them stand out a little better. There is now a dual-extrusion version with inlaid numbers if you prefer that instead.
Just insert the header fully into the pocket and then snap the excess section of header.
For 2 to 5 pins, you can snap the header in either direction.
For 6 to 13 pins, snap toward the odd or even side.