1 / 3
Front of gantry routing of cable for SilencedFrost front rail hanger — zdjęcie 1
1 / 3

Front of gantry routing of cable for SilencedFrost front rail hanger

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

extruder adaptor for routing cable to Layer.shifted cable chain system from the SilencedFrost front rail hanger

Ocena
0 / 5
Polubienia
1
Pobrania
18
Wydruki
0
Wyświetlenia
202
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

There has been no adaptor built to date that would allow cable to be routed behind the gantry if there z-rail upgrade has been done.   This will twist the cable off the extruder, route through the cable chain to the transition adaptor which sits on top of the limit switch.

Attatch the transition guide to the angle slot in the gantry hanger using a M3x10 FH screw into a heated insert in the hanger nut.   The nut should twist 90° on the back side of the hanger slot.

attach cable chain to front of transition piece to route down to bottom of printer

print flat side down on each piece

Extruder adaptor will require support  for cable link section .   Tree (auto) organic works best

paint a support on the 90° adaptor angle slot index.   Using normal (manual) snug

to mount extruder bracket - 2 M3 heat inserts are required in the top 2 mounting holes