1 / 3
Front of gantry routing of cable for SilencedFrost front rail hanger — image 1
1 / 3

Front of gantry routing of cable for SilencedFrost front rail hanger

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

extruder adaptor for routing cable to Layer.shifted cable chain system from the SilencedFrost front rail hanger

Rating
0 / 5
Likes
1
Downloads
18
Makes
0
Views
203
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial — Share Alike

There has been no adaptor built to date that would allow cable to be routed behind the gantry if there z-rail upgrade has been done.   This will twist the cable off the extruder, route through the cable chain to the transition adaptor which sits on top of the limit switch.

Attatch the transition guide to the angle slot in the gantry hanger using a M3x10 FH screw into a heated insert in the hanger nut.   The nut should twist 90° on the back side of the hanger slot.

attach cable chain to front of transition piece to route down to bottom of printer

print flat side down on each piece

Extruder adaptor will require support  for cable link section .   Tree (auto) organic works best

paint a support on the 90° adaptor angle slot index.   Using normal (manual) snug

to mount extruder bracket - 2 M3 heat inserts are required in the top 2 mounting holes