Flitetest FT Tutor Battery Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple and somewhat weight-optimized easy print to replace the dinky foam battery cover.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 82
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
A simple battery cover replacement for the FT Tutor. Just some supports on the pegs and you're good to go. 2 versions, one with holes to make it easier to pull out.
I printed in PLA with .25 layer, 2 wall, 2 base, 2 roof, 10% infill to save weight.
Disclaimer: When I built my FT Tutor, I thought I followed the videos to a T. For some reason my front end needed modification. I don't know if this was a mistake on FT's part or mine, but nonetheless this battery cover fits MY plane, and MAY fit yours. Measure beforehand if you're worried. A file works wonders too. I built mine a while ago, but I think my battery cover was trimmed to be shorter.