Makita MAKPAC storage organizer inserts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Custom inserts for the MAKPAC storage organizer boxes. Print your set of inserts to match your storage needs!
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 132
- Wydruki
- 1
- Wyświetlenia
- 1208
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
Subdividers or inserts
There are four versions right now. I only made these available for the 1x1 storage boxes, as you can subdivide a 2x1 box by using two 1x1 ones instead :)
- Lower divider - with half and with quarter subdivision
- Upper divider - with half and with quarter subdivision
- (there are no dividers for the larger boxes right now)
Storage boxes
Other misc parts
- coming soon
Print settings
You can print all models upright, with the default settings. For the boxes you have turn supports on as the bottom of the boxes are floating in the air. For the inserts you do not need any support.
As far as the print surface adhesion goes, the boxes are a bit tricky to print, because the area they have on the baseplate is very small. I recommend using brims if you have problems with adhesion. For me, the smooth PEI sheet was a little bit too much adhesion, I had separation problems after the print using PETG. PLA is fine.