Small pet bridge/ramp/steps system
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Easy system to build quick bridges, ramps, and steps for small pets to climb into enclosures or across gaps.
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 438
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial
I have simplified my original design and derived these basic block elements for faster printing.
These parts come together to build quick bridges, ramps, and steps for small pets to climb into enclosures, between play areas, or across gaps.
The steps have a 25mm height between them, if my tortoise can easily make that then I suspect most pets can :)
----- ----- -----
Designed for my Russian tortoise (Donatello), so the steps have a good grip pattern for his little claws.
Frame pieces must be printed in mirrored pairs.
Prints without supports. The frame pieces should be orientated with their inside on the plate, the steps with their bottoms on the plate. The M3-clearance holes have a 0.2mm layer at the bottom to allow for supportless bridging, they can easily be punched through after printing.
For assembly, it is recommended to use M3 bolts with threaded inserts in the steps. Otherwise, the steps are naturally quite a good push fit, so they can be held permanently with only a small amount of glue.
I used Marble, and Grass Green PLA by CC3D. 0.2mm layers, 0.4 nozzle, Neptune 4 Pro.