Snap-on shell for HappyModel 1S USB Charger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple snap-on shell for the HappyModel 1S PH2.0 JST USB Charger.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 84
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This simple two-piece shell snaps together to protect the HappyModel 1S USB Charger.
As these boards are so simple, it's possible not all will have the same dimensions as mine, but in my case, it fits nice and snug.
Take care not to break the board when seating it on the bottom because the board has some fragile points, such as the USB connector and both battery connectors. You need to give it a little force to get the board past the snap tabs. I won't be responsible if you break your board!
Corrected LiHC to LiHV, thanks to /u/gigasawblade for catching that.